Trying to lengthen my shower hose. It’s the one that pulls out of the tap, but it always cut off if trying to attach it to the hook on the wall. A couple of years ago the supplier added a silicon Pipe to prevent The hose kinking, the result being the shower head no longer reached to hook at all. It’s made by Argo and it a Rollerteam.
During our down time I have dismantled the sink and was hoping to replace the flexible tap tail with a longer one. It has an M8 threat that screws into the bottom of the mixer tap But the other end that screws onto the hose is not the standard 1/2” or 3/4” found on domestic taps. Seems to be close to 15mm (14.7).
Any idea where I might get a replacement flexible tail at 500mm With a non imperial fitting or something that I could fit between the existing connectors to make it longer. Help!
During our down time I have dismantled the sink and was hoping to replace the flexible tap tail with a longer one. It has an M8 threat that screws into the bottom of the mixer tap But the other end that screws onto the hose is not the standard 1/2” or 3/4” found on domestic taps. Seems to be close to 15mm (14.7).
Any idea where I might get a replacement flexible tail at 500mm With a non imperial fitting or something that I could fit between the existing connectors to make it longer. Help!
The first one above seems to be a compression fitting and the second is M10. So called at the plumbers Merchant who tried the threads but they were just slightly bigger than mine. Must be a European fitting? Did try Leisure shop, no joy.
