finally have my refurbished truma c3400 refitted at last, but it wont ignite.
I have checked the following
its getting gas at the boiler ( new cylinder)
its sparking ( can hear it at the vent)
12.9 v even with the fan running
3 fuses in circuit board ok
checked all connections
It was working fine before i removed it, all original bits reconnected, only non original part is the aluminium vessel
when its switched on the fan starts as normal and orange light shows, i can hear the igniter at the vent, the fan stops then the red light comes on.
Any advice welcome
Cheers
I have checked the following
its getting gas at the boiler ( new cylinder)
its sparking ( can hear it at the vent)
12.9 v even with the fan running
3 fuses in circuit board ok
checked all connections
It was working fine before i removed it, all original bits reconnected, only non original part is the aluminium vessel
when its switched on the fan starts as normal and orange light shows, i can hear the igniter at the vent, the fan stops then the red light comes on.
Any advice welcome
Cheers
