I am looking for advice on how to source and replace a rocker switch on my Schaudt Electroblock EBL 263-5. It is the 12v supply on-off switch shown in the attached (I hope) photos. The rocker must have popped out at some stage and what I assume must be a little brass piece that makes and breaks the contacts inside is missing. The markings on the switch body include the following: 1808 6A 125-250VAC 1/8 HP.
The closest I have come to finding a replacement component on-line is a Marquardt switch (1801.6102 SPST on-off) but it only has two pins for connecting to the PCB.
I have a feeling that removing the switch in the way I did was a mistake as the pins were presumably soldered into the PCB.
Any help or advice would be appreciated.
The closest I have come to finding a replacement component on-line is a Marquardt switch (1801.6102 SPST on-off) but it only has two pins for connecting to the PCB.
I have a feeling that removing the switch in the way I did was a mistake as the pins were presumably soldered into the PCB.
Any help or advice would be appreciated.
You must be logged in or your permissions are to low to see this Attachment(s).